Home         The Company         Models        How Cel-Fi Works         Benefits of Cel-Fi         Support         Blog         Contact Apply

 
Home
  Models
  Telstra GO Mobile

Cel-Fi GO mobile for Telstra 3g & 4g

Cel-Fi GO Mobile Repeater has been tested, authorised and approved by Telstra for use on the Telstra Mobile Network.

Nextivity's Cel-Fi GO is an intelligent in vehicle coverage solution for Telstra's Next G® and 4GX networks operating on 3G 850Mhz and 4G 700/1800 bands. It is designed to dramatically boost voice quality and increase data speeds for moving vehicle applications.

The Cel-fi GO differs greatly from the standard vehicle repeater due to its ability to not interfere with the mobile network or other users. Often referred to as a Smart Repeater, Cel-Fi GO has the ability to provide maximum coverage and be network friendly.

It does this in several ways by

  • continuously monitoring power levels of the cell tower it is connected to and constantly adjusting the Cel-Fi's output power to suit.
  • only amplifying and disbursing a particular carrier’s mobile signal, operating within a set frequency band.
  • not interfering with the carrier’s network or other users on the network.
  • having a unique installation process to eliminate feedback into the mobile network.

    Cel-Fi GO is covered by a 24 month warranty.

Important Note: Cel-Fi GO will boost a single band at a time (either 3G 850 or 4G 700 or 4G 1800). It is highly recommended to leave the GO in 3G mode to ensure voice calls are received. Voice on 4G (VoLTE) will only work in selected areas and with later model phones.

 

Cel-Fi GO for Telstra

     MOBILE MODEL

            Made for vehicles and transport applications
            70dB of system gain
            Will only start boosting once the mobile signal drops below                -80dBm (3G) or -96dBm (4G)
            Includes external and internal antennas
            Locked to Telstra's Mobile Network
            Carrier approved
            Band Selection Button
            Bluetooth WAVE App for iPhone, Android & Computers

            
30 Day Money Back Guarantee*
If you are not 100% happy with the performance of this product
it can be returned within 30 days after purchasing for a full
refund minus any shipping charges... terms and conditions

 

Downloads

 Cel-Fi GO Mobile Brochure

 Cel-Fi GO Mobile Quick Start Guide


Supported Networks

Telstra, Aldi Mobile, Boost Mobile,
Woolworths Mobile


Cel-Fi GO mobile PACKS

Cel-Fi GO Repeater for Telstra - Mobile Pack

Cel-Fi GO Repeater for Telstra - Trucker/4WD Pack

Cel-Fi GO Repeater for Telstra - Emergency Vehicles GPS Pack

VIEW ALL

 
 

Easy Purchasing Procedure

     
 
STEP 1
- Complete the Application
As a regulatory requirement you first need to answer some simple questions and complete a registration form.

   

 
STEP 2
- Place Your Order
Once you have completed your application you will need to place your order with Powertec Telecommunications who will ship your order usually on the same day.


 
 

Specifications

FREQUENCY

UMTS/3G 850 - Band 5
Uplink: 824 - 849 MHz, Downlink: 869 - 894 MHz
4G 700/1800 - Band 28 & 3
Uplink: 703 – 733 MHz, Downlink: 758 – 788 MHz
Uplink: 1710 – 1785 MHz, Downlink: 1805 – 1880 MHz
(Will only boost a single frequency at a time)

DATA

UMTS / HSPA / HSPA+/ LTE (FDD)

GAIN

Up to 70dB system gain

BOOSTING THRESHOLD

Will only boost between these signal levels:
3G: -80dBm and -104dBm
4G: -95dBm and -119dBm

BAND SELECTION

Button for band selection:
3G: 850
4G: 700 or 1800 (strongest signal)
AUTO: 850, 700 or 1800 (strongest signal)

NETWORK UNIT

H: 28mm
W: 87mm
L: 255mm
Weight: 600g

 




ENVIRONMENT
Operating Temperature: 0° to 65°C
Storage Temperature: -25° to 65°C
Relative Humidity: 0 to 95% noncondensing
POWER
12 VDC via external supply (2 included)
External Supply: 100-240 VAC, 47-63Hz
Power Consumption: <15W per unit
INTERFACES
External Antenna Ports: Donor and Service SMA Female
Programming Ports: Mini-USB
Bluetooth Low Energy
WARRANTY
24 months
CERTIFICATIONS

CE Mark
C-TICK
FCC
RCM

 

 
 

INSTALLATION

Cel-Fi GO is a state of the art, very complex “Smart Repeater” and is approved by Telstra if installed correctly.

It is guaranteed to provide massive signal enhancement in poor reception areas, however incorrect installation may significantly reduce performance.

Installation of a Cel-Fi GO is best done by a qualified installer. Only qualified Powertec Telecommunication Resellers who have undertaken product training on the required precautions should perform installation of the Cel-Fi GO.

Vehicular Cel-Fi GO Packs in particular require you to take into account the vehicle’s safety mechanisms such as airbags, ABS, Traction Control, Stability Control and the auto electrics. Incorrect installation may result in water leaks, electrical failure, battery damage, fusing of internal wiring and cables or risk of FIRE. Misuse of this equipment could result in injury and equipment damage. In no event will Powertec Telecommunications P/L be responsible or liable for either indirect or consequential damage or injury that may result from the installation or use of this equipment.

If the above precautions are not fully understood, or if local conditions are not covered, contact your nearest Powertec Telecommunications sales or service representative for clarification.

You should also be familiar with applicable federal, state and local legislation and industry standards surrounding installations.

YOU SHOULD BE TRAINED IN HANDLING, INSTALLING, OPERATING AND MAINTAINING THE CEL-FI GO BEFORE YOU WORK ON ANY CEL-FI GO SYSTEM.

 

CEL-FI GO BLOG POSTS

GO to the NT
Thanks to staff at Centre For Appropriate Technology in Darwin for undertaking testing of Cel-Fi GO across outback NT. Great results achieved in some very remote communities.

Testing Different Antennas With Cel-Fi GO
During our GO testing we tested several different antenna types to see the effect this had on the boost and the final signal strength on the phone.

Installing GO in a Car
This article explains how to install Cel-Fi GO in a car, different setups and what performance you can expect.

The Cel-Fi GO Booster Models
If you are wondering why the Cel-Fi GO comes in two flavours, a ‘Stationary’ & ‘Mobile’ version, then this is the article you need to read.

Cel-Fi WAVE App
Cel-Fi WAVE offers a window into what is happening within the heart of a Cel-Fi smart booster. It also enables you to control certain features of the unit.

Cel-Fi GO – LED Indicators Explained
As Cel-Fi GO is only able to boost one frequency band at a time, a way of indicating and switching between frequency bands was developed by using a button. The button enables the selection of 3G, 4G/4GX or AUTO (band with strongest signal). An LED indicator displays which band GO is currently boosting.

Unboxing the Cel-Fi GO for boosting mobile phone signal in a car
Today we decided to unbox the Cel-Fi GO Mobile Version, the new repeater for boosting a mobile signal in a car.

 

* 30 Day Money Back Guarantee - Customer must return the Cel-Fi repeater within 30 days of receiving if the product does not perform to their expectations. Item must be returned with all packaging and parts in original condition. Refund component does not include any shipping charges paid.
* Telstra Approval - Customers must undertake an approval process to determine the product is suitable for their location. A Telstra approval form will need to be completed and signed by the customer.

® is a registered trade mark of Telstra Corporation Limited. ABN 33 051 775 556

 
 
 
 

  Main Menu

» Home
» The Company
» Models
» Cel-Fi for Telstra
» Cel-Fi PRO for Telstra
   Cel-Fi for Optus

   Cel-Fi for Vodafone
» How Cel-Fi Works
» Benefits of Cel-Fi
» Blog
» Support
» Contact Us

  Australian Distributor

Powertec Telecommunications Pty Ltd
16/511 Olsen Ave
Southport Qld 4215
Australia

 www.powertec.com.au

  Contact Us

 +61 7 5577 0500

 +61 7 5577 0599

 sales@powertec.com.au

  The Company

Powertec is a telecommunications distributor, specialising in mobile routers, gateways and repeater systems.

Facebook

Keep up to date with us on Facebook

Copyright © 2015 Powertec Telecommunications Pty Ltd & Nextivity Inc. All Rights Reserved. ® is a registered trade mark of Telstra Corporation Limited. ABN 33 051 775 556